Optimizing the EDM Parameters to Improve the Surface Roughness of Titanium Alloy (Ti-6AL-4V)
Shailendra Kumar Singh1, Narinder Kumar2
1Er. Shailendra Kumar Singh, Mechanical Engineering Dept, Rayat and Bahra Institute of Engineering and Bio-technology, Punjab, India.
2Er. Narinder Kumar, Assistant Professor in Mechanical Engineering Deptt, Rayat and Bahra Institute of Engineering and Bio-technology, Punjab, India.
Manuscript received on August 11, 2013. | Revised Manuscript received on August 15, 2013. | Manuscript published on August 25, 2013. | PP: 10-13 | Volume-1, Issue-10, August 2013. | Retrieval Number: J04070811013/2013©BEIESP
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Published By: Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The purpose of this paper is to optimize the EDM parameters to get the better surface finish on the Titanium alloys Ti- 6AL- 4V. The continuous advancement of the alloy is fulfilling the demand of the industry but for advance material like Titanium alloys Ti- 6AL- 4V partially adopted by industries cause of the difficulties in machining. Non Conventional machining process like Spark Erosion Electrical Discharge Machining (EDM) is the process of machining these hard alloys. The designs of experiment for machining process control parameter are Pulse Time (Ton), Pulse off (Toff) and Current (I), while tool used for machining alloy Ti- 6AL- 4V was Copper (Cu) electrode. The experimental results have given optimal combination of input parameters which give the optimum surface finish of the EDM machined surface.
Keywords: Surface Roughness, Taguchi, ANOVA, Current, EDM